Ultimaker 2+

Ultimaker 2+ User Manual
https://ultimaker.com/download/11715/UserManual_UM2+_EN.pdf
Mon, 6 Aug, 2018 at 11:10 PM
Flooded PrintHead
The best process if you wish to do the repair yourself is to manually heat the nozzle using the on display control (heating to 240deg) Once the nozzle hea...
Tue, 7 Aug, 2018 at 12:30 AM
Brown Out - Printer Suddenly Shuts Off or Reboots
The first question to ask in this situation is one that seems a little obvious. But is the power cable plugged into the printer properly? It actually has a c...
Mon, 6 Aug, 2018 at 11:48 PM
Build Plate Adhesion
Prints not Sticking or Sticking too Well Key Points: Adhesion Options Build Plate - Level and Clean Print Head Tight, Clean and Clear Cura Settings...
Tue, 7 Aug, 2018 at 12:06 AM
Blocked Nozzle
Clear a blocked nozzle via the following process: https://ultimaker.com/en/resources/149-atomic-method It may take a good couple of tries to get it righ...
Tue, 7 Aug, 2018 at 12:55 AM
Feeder Grinding
Generally there is only 2 reason for feeder (extruder) to grind a 'bite' out of the filament : Feeder tension is to high - Should always be set ...
Tue, 7 Aug, 2018 at 12:47 AM